Filter
Top Products
29
Safety Instructions Operating InstructionsSafety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support
GEAppliances.com
Problem Possible Causes What To Do
Storage drawer
Power cord may be • Reposition the drawer and power cord. See the
won’t close
obstructing drawer
Storage Drawer Removal
instructions in the
Care and
in the lower back
cleaning of your range
section.
of the range.
Rear drawer support is • Reposition the drawer. See the
Storage Drawer
on top of the guide rail.
Removal
instructions in the
Care and cleaning of your
range
section.
Oven will not self-clean
The oven temperature is • Allow the oven to cool to room temperature and
too high to set a self-clean reset the controls.
operation.
Oven controls improperly set. • See the
Using the self-cleaning oven
section.
“Crackling” or
This is the sound of the • This is normal.
“popping” sound
metal heating and cooling
during both the cooking and
cleaning functions.
Excessive smoking
Excessive soil. • Press the
CLEAR/OFF
pad. Open the windows to
during a clean cycle
rid the room of smoke. Wait until the
LOCKED
door
light goes off. Wipe up the excess soil and reset the
clean cycle.
Oven door will not
Oven too hot. • Allow the oven to cool below locking temperature.
open after a
clean cycle
Oven not clean after
Oven controls not properly set. • See the
Using the self-cleaning oven
section.
a clean cycle
Oven was heavily soiled. • Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
“LOCK DOOR” flashes
The self-clean cycle has been • Close the oven door.
in the display
selected but the door is not
closed.
LOCKED DOOR light
The oven door is locked • Press the
CLEAR/OFF
pad. Allow the oven to cool.
is on when you want
because the temperature
to cook
inside the oven has not
dropped below the
locking temperature.
“F— and a number
You have a function • Press the
CLEAR/OFF
pad. Put the oven back into
or letter” flash
error code. operation.
in the display
If the function code repeats. • Disconnect all power to the range for at least 30
seconds and then reconnect power. If the function
error code repeats, call for service.