Filter
Top Products
13
Consumer Support
Operating Instructions
Safety Instructions Care Instructions Troubleshooting Tips
Problem Possible Causes What To Do
Dishwasher won’t run Fuse is blown, or the • Replace fuse or reset circuit breaker. Remove any other appliances
circuit breaker tripped from the circuit.
Power is turned off • In some installations, the power to the dishwasher is proved through a
wall switch, often located next to the disposer switch. Make sure it is on.
Reboot your control • Turn off power to the dishwasher (at circuit breaker or wall switch) for
30 seconds, then turn back on.
Steam This is normal • Steam comes through the vent during washing, drying and when
water is being pumped out.
Control panel Door latch may not be • Make sure the door is firmly closed.
responded to input properly seated
but dishwasher never
filled with water
Water valve may be • Make sure water valve (usually located under the sink) is turned on.
turned off
Dishwasher beeps This is normal • Close the door after opening it mid-cycle.
once every 15 seconds
This is a reminder that the • Press ON/OFF to turn OFF the dishwasher.
door has been left open
during operation
Beeping at the end This is normal • The dishwasher will beep and the CLEAN light will display at the end
of the cycle of the wash cycle.
LOW RINSE AID Rinse aid dispenser • This can only be turned off by filling the rinse aid dispenser with Jet-Dry
®
light is on needs to be refilled or Cascade Crystal Clear
®
.
See Refilling the Rinse Aid Dispenser section.
ge.com