Filter
Top Products
OPERATION
Before first use
Remove all packaging materials, labels and/or stickers from your kettle.
Clean your kettle thoroughly before using for the first time ( Cleaning).
Boil water at least 2 times and dispose, before boiling water for consumption.
Remove the kettle from the base (9). Push the lid release button (3) to open the
lid (2).
Fill the kettle with water (ill.
a
) up to the max 1.7 marking (ill.
b
). Close the lid (2)
(ill.
c
).
Connect the power plug (6) to a wall outlet (ill.
d
). Press down the I/0 switch (7) to
on position to start boiling the water (ill.
e
).
The I/0 switch (7) lights up. After boiling is finished, the kettle turns off automatically.
Dispose of the hot water in the sink.
WARNING: Be careful when handling hot water. Danger of scalding!
Let the appliance cool down 1 minute before boiling water again. Repeat this
process at least 2 times before using water for consumption.
WARNING: Do not immerse the base (9) or the kettle in water or any liquids. This may
cause electric shock or damage the appliance.
Operating instructions
Before plugging the kettle into the wall outlet, check that the electrical circuit is not
overloaded with other appliances.
Set the base (9) on a flat, even and steady surface.
Remove the kettle from the base (9). Push the lid release button (3) to open the
lid (2).
Fill the kettle with water (ill.
a
) between the min 0.75 and the max 1.7 marking (ill.
b
). Do not fill under the min or over the max marking. See the water gauge (5) for
adding the desired amount of water. Close the lid (2) (ill.
c
).
Connect the power plug (6) to a wall outlet (ill.
d
).
Press down the I/0 switch (7) to on position to start boiling the water (ill.
e
). The
I/0 switch (7) lights up.
After boiling is finished, the kettle turns off automatically.
Let the appliance cool down 1 minute before boiling water again.
Pour the hot water into a heat resistant container (ill.
f
).
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
6
169205-EN-04.indd 6 4/27/2009 2:40:09 PM