Filter
Top Products
13
Installation Instructions
REVERSING THE DOOR SWING
2
When reversing the door swing:
• Read the instructions all the way through before starting.
• Handle parts carefully to avoid scratching paint.
• Set screws down by their related parts to avoid using them
in the wrong places.
• Provide a non-scratching work surface for
the doors.
IMPORTANT:
Once you begin, do not move the cabinet
until door-swing reversal is completed.
These instructions are for changing the hinges from
the right side to the left side—if you ever want to change the
hinges back to the right side, follow these same instructions
and reverse all references to left and right.
IMPORTANT NOTES
Phillips screwdriver
TOOLS REQUIRED
Masking tape
T20 or T25 Torxdriver
(needed for some models)
5/16” hex-head
socket driver
5/16” open-end
wrench
Putty knife or thin-blade
screwdriver
2.1
Tape the door shut with masking tape.
2.2
With a 5/16” hex-head socket driver, remove the
screws that hold the top hinge to the cabinet.
REMOVE THE FREEZER DOOR
2
2.3
Lift the hinge straight up to free the hinge pin from
the socket in the top of the door and set it aside,
along with its screws.
Top Hinge
2.6
Transfer the 2 screws from the opposite side of the
cabinet to the screw holes vacated by the top hinge
removal.
2.5
Set the door on a non-scratching surface with the
outside up.
2.4
Remove the tape and tilt the door away from the
cabinet. Lift it off the center hinge pin.
1.1 Unplug the refrigerator from its electrical outlet.
1.2
Empty all door shelves, including the dairy
compartment.
CAUTION:
Do not let either door drop to the floor. To
do so could damage the door stop.
BEFORE YOU START
1