Filter
Top Products
– 27 –
Washability Complaints
Hot Water – Ample supply of water at a minimum
temperature of 120 °F is necessary. Do not use
dishwasher soon after using clothes washer or
filling bath tub.
Loading – Consult Owner’s Manual on loading
procedures.
Amount of Water – Make sure dishwasher is
level. Check water level, allowing dishwasher to fill
normally for first fill. The water level should be
to the base (bottom) of the float dome. If water
level is low, check for clogged screen in water
valve and check flood switch. Refer to the
Water
Valve and Flood Switch
section.
Detergent/Rinse Module Leakage – Some
moisture in cup is normal. Detergent must not be
soaking wet, oozing out and down the inner door
panel. If a leak is detected, check the detergent/
rinse module door lid, latch operation, and gasket
seal. Also refer to the
Detergent/Rinse Module
section.
Proper Amount of Detergent – Use full detergent
cup of fresh detergent in hard water. Use only
enough detergent to get good wash performance
in soft water.
Rinse Agent – Use rinse agent if spotting or
drying is a problem. A rinse agent will improve the
water sheeting action and drying performance.
Water Valve – Refer to the
Water Valve and Flood
Switch
section.
Spray Arm – Check to be sure all 3 spray arms
spin freely and jets are not clogged. Check to be
sure the middle spray arm water conduit is con-
necting properly to the main conduit.
Drying – Water inlet temperature must be at least
120 °F for proper drying. Low water inlet tempera-
ture will prevent proper convection air movement
and increase drying time substantially.
A rinse agent will improve the water sheeting
action and drying performance.
Cover
latch
Pre-wash
section
Main
wash
section
Cover
Rinse
agent
Detergent/Rinse Module
Float Dome
Water Level