Filter
Top Products
• Connect drain line to air gap, waste tee or disposer
using the previously determined method. Secure hose
with a screw type clamp.
Waste Tee Installation
Method 1 – Air gap with waste tee or disposer
Disposer Installation
Waste Tee Installation
Method 2 – “High drain loop” with waste tee or disposer
With this method you will need the drain hose hanger set
aside
in Step 1.
Fasten drain hose to und
erside of countert
op with the provided
hanger.
Disposer Installation
Figure Y
Figure Z
IMPORTANT
–
When connecting drain line to
disposer, check to be sure that drain plug has been removed.
DISHWASHER WILL NOT DRAIN IF PLUG IS LEFT IN PLACE.
756Dia60
756Dia61
Dishwasher Installation
STEP 17: CONNECT DRAIN LINE
The molded end of the drain hose will fit 5/8" through 1"
diameter inlet ports on the air gap, waste tee or disposer.
• Determine size of inlet port
• Cut drain hose connector on the marked line, if required, to fi t
the inlet port.
• If a longer drain hose is required and you did not purchase
drain hose GPF10L, add up to 42" length for a total of 120"
(10 feet) to the factory installed hose. Use 5/8" or 7/8" inside
diameter hose and a coupler to connect
the two hose ends.
Secure the
connection
with hose
clamps.
Figure W
Figure X
Note:
TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 10 FEET
FOR PROPER DRAIN OPERATION.
Remove
Drain
Plug
1871 Art1
Tip:
Avoid unnecessary service call charges for a no drain
complaint
Make sure excess drain hose has been pulled through
the cabinet opening. This will prevent excess hose in the
dishwasher cavity from becoming kinked or crushed by the
dishwasher.
STEP 16: CONNECT WATER SUPPLY
Connect water supply line to 90° elbow.
• Slide compression nut, then ferrule over end of water line.
• Insert water line into 90° elbow.
• Slide ferrule against elbow and secure with compression nut.
IMPORTANT
–
Check to be sure that door spring
and/or door spring cable do not rub or contact the fi ll hose or
water supply line.
Test by opening and
closing the door.
Re-route the water
supply lines if a
rubbing noise or
interference
occurs.
Figure V
90° Elbow
Ferrule
90° Elbow
Door Spring
756Dia57
Hot Water
Supply Line
Compression
Nut
1871 Art4
Cutting Line
1"
5/8"
IMPORTANT: Do not cut corrugated
portion of hose
18"
Min.
32"
Min.
05D-1294C
32"
Min.
18"
Min.
05D-1294B
Drain Hose Hanger
11