Filter
Top Products
5
Feed Water Supply
Check and comply with local plumbing codes as you plan,
then install a cold feed water supply fitting. For new home installation
using standard plumbing fittings, see first two illustrations below. A typical
installation for existing homes using the saddle valve is shown in third
illustration below.
A. PREFERRED INSTALLATION
Turn off the cold water supply.
Complying with plumbing codes, install a fitting on the cold water pipe
to adapt 3⁄8″ OD tubing. A typical connection is shown in illustrations at
right (parts not included). Make sure a water supply valve is used.
2
1
B. OPTIONAL HOME INSTALLATION Where codes permit
*For 1/2" OD or larger metal tubing only.
NOTE: Codes in the state of Massachusetts require installation by a licensed
plumber and do not permit the use of the saddle valve. For installation,
use plumbing code 248-CMR of the Commonwealth of Massachusetts.
Turn off the cold water supply and attach saddle valve as shown in
illustration at right.
DANGER: To protect yourself from serious injury or fatal shock, use
a battery-powered hand drill only to make the hole. DO NOT USE AN
ELECTRIC DRILL.
Close the water supply valve by turning the handle clockwise.
Open the main water supply valve and several house faucets to purge
air from the system. Close faucets when water runs smoothly.
3
2
1
Optional water supply connection (using saddle valve)*
Pre-drill
1⁄4″hole
Seal—make sure the
seal is in place
Clamp X
Nut (2)—not
required if holes
in clamp are
threaded
Valve
Handle
Tubing adapter
Tubing insert
Compression nut
Clamp Z
Preferred water supply connection
(using compression fitting)
Insert (not included)
Cold
water
pipe
3⁄8″tubing to inlet
Ferrule
Water supply valve
Typical location
Cold
water
Use to connect the tubing
*For 1/2" OD or larger metal tubing only.
Snug valve into bracket
DO NOT OVERTIGHTEN
Some threads
should be visible
Rubber gasket