Filter
Top Products
6
Step-by-step installation instructions.
Faucet Installation
Be sure there is room underneath the sink to make the needed connections.
Select one of the following places to install the faucet:
—IN an existing sink spray attachment or soap dispenser hole.
—IN a hole to be drilled in the sink top.
—IN a hole to be drilled in the countertop, next to the sink.
NOTE: Looking at second illustration at right, be sure the faucet base will fit
flat against the surface at the selected location so the gasket will seal.
If drilling is needed, make a 3⁄4″ dia. hole. Be sure to use the proper
procedure for drilling porcelain or stainless steel. Special drill bits
may be needed.
Place small gasket, base and large gasket (in that order) onto the
faucet stem. Next, place lock washer and hex nut onto faucet stud.
Insert tubing insert into tubing adapter. Securely tighten to faucet stud.
Feed the length of 3⁄8″ OD tube from the bottom, up through the
mounting hole. Connect to the tubing adapter as shown in second
illustration, tightening the compression nut securely.
Remove the short shipping tube and insert the spout into the
faucet body. Rotate spout into place.
Lower the faucet assembly into place on the underside of the mounting
hole. Place
the mounting bracket above the lock washer. While holding
the mounting bracket in place, securely tighten the hex nut.
6
5
4
3
2
1
Sink
Base
Lock washer
Faucet
Lever
Spout
Faucet
stud
Small gasket
Large gasket
Compression nut
Tubing adapter
Mounting bracket
Hex nut
Tubing insert
3/8″tubing, (run
to Filter outlet)
Compression nut
ASSEMBLED
Tubing adapter
Tubing insert