Filter
Top Products
Customer ServiceTroubleshooting TipsOperating InstructionsSafety Instructions Installation Instructions
Repeat steps 2 through 7 for the taste/odor (FXUTB) filter cartridge in the
Filter II sump
Open the filtered water faucet. Then, slowly open the water supply/saddle valve and allow the filter
housing to fill.
Close the filtered water faucet. Then, check for leaks between the sump and the head.
NOTE:
If leaking, turn off the water supply and open the filtered water faucet. Then,
disassemble the
filter and check the o-ring for cuts, flat spots, etc., and sealing surfaces for foreign material. Clean the o-
ring and lubricate with clean silicone grease. Carefully press into the groove in the sump.
The filter cartridges contain activated carbon. When new, open the filtered water faucet for ten minutes
to flush the system.
11
10
9
8
Fig. 5
Filter
I
O-ring seal
Cartridge
Sump
Sump
Replacement label
TURN SUMP
TO INSTALL
TURN SUMP
TO REMOVE
Head
Bracket
Sump
wrench
To
loosen
11
Filter
II