Filter
Top Products
Installation Overview
7
Installation Instructions.
Customer Service
Troubleshooting Tips
Operating InstructionsSafety Instructions Installation Instructions
Important Installation Recommendations
Read entire manual. Failure to follow all guides and rules could cause personal injury or property damage.
■
Check with your local public works department for plumbing codes. You must follow their guides as you install
the Water Filtration system.
■
Use the Water Filtration system on a potable, safe-to-drink, home COLD water supply only. The filter cartridges will
not purify water or make unsafe water safe to drink. DO NOT use on HOT water (100° F. max.).
■
Protect the Water Filtration system and piping from freezing. Water freezing in the system will damage it.
■
Your Water Filtration system will withstand up to 125 psi water pressure. If your house water supply pressure is
higher than 100 psi during the day (it may reach higher levels at night), install a pressure reducing valve before
the system.
WARNING:
Do not use with water that is microbiologically unsafe or of unknown quality without adequate
disinfection before or after the system. The water should be tested periodically to verify that the system is
performing satisfactorily. Small parts remaining after the installation could be a choke hazard. Discard safely.
■ Slotted and Phillips screwdrivers
■ Pliers and adjustable jaw wrench
■ Hand or battery powered drill and 1⁄4 ″bit
(saddle valve installation)
■ Electric drill and drill bit to drill 1″−1-1⁄4″ hole
(type as required) if mounting hole is needed for
faucet
CAUTION:
To avoid damaging the sink, consult
a qualified plumber or installer for drilling
procedures. Special drill bits may be needed
for porcelain or stainless steel.
Contents included with the product:
■ Water filter assembly, including mounting bracket
and screws
■ Product Literature (Owner’s Manual and
Installation, Product Data Sheet, Owner Product
Registration Card)
■ Water supply/saddle valve
■ Filtered water faucet, for sink or countertop
mounting
■ 3
⁄
8″ tubing and fittings to make all needed
connections
■ Sump wrench
Fig. 1
Filtered
water faucet
Sink
Hot
Shutoff valve
NOTE:To change the filter cartridge, you
must turn off the water. A nearby shutoff
valve is convenient. Most sinks already have
shutoff valves on the supply pipes.
Cold
Water supply/saddle valve
Washer
Adapter
Nut
Water
in
Water
out
Tubing
Insert
Mounting
screw (2)
Filter
I
Filter
II
Nut
Tubing
1-1/2″ to 2″
Locate the drinking water
system on the cold water
supply pipe, under the
kitchen and/or bathroom
sink, to filter the cold
drinking water.
Tools and Materials Required for Installation