Filter
Top Products
Installation Instructions
STEP 4 FASTEN PANEL SUPPORT BRACKET
TO UNDERSIDE OF COUNTERTOP
AND TOEKICK PANEL TO FLOOR
Fasten the panel support bracket to the underside of the
countertop using two #8 x 3/4" wood screws and two 3/16"
flat washers.
Mount Panel
- Support Bracket
I to Underside of
STEP 6 POSITION PANEL AGAINST BACK OF
CABINET
Skip this step and go to Step 10 if the back of the dishwasher
enclosure is not a wall or if gou choose not to fasten the side
panel to the back of the dishwasher enclosure.
Gentlg push side panel against the rear wall of the dishwasher
enclosure. Mark the location of the screw cutouts in the panel
on the back wall of the enclosure.
÷
?
Mount Toe _d_,
Kick Panel-- _]\
to Floor Figure D
Fasten the toekick panel to the floor using two #10 x 1" wood
screws and two 3/16" flat washers.
If the floor isceramic tile or similar material that will not accept
screws, use two lag bolts of appropriate size and length along
with 2 flat washers to fasten the toekick panel to the floor.
STEP S LOOSELY INSTALL SIDE PANEL
Mount the side panel to the toekick panel and panel support
bracket using four 1/4"x 3/8" machine screws, 4 lock washers
and four 1/4" nuts. Do not tighten the fasteners at this time.
Figure E
Figure F
STEP 7 DETERMINE WALL COMPOSITION
If wall issolid or there is a stud behind the panel, attach the
panel to the wall using two #10 x 1" wood screws and two
3/16" flat washers. Install the screws Iooselg - do not tighten.
Skipto Step 10
If wall is hollow, for example, drgwall without a stud, it will
be necessarg to usetoggle bolts to attach the side panel to
the wall.
STEP 8 INSTALL TOGGLE BOLTS
Remove side panel from toekick and support bracket. Drill a
1/2" hole at each of the positions marked in Step .6.Place a
washer on the 3" machine screw. Screw the toggle onto the
bolt a few turns. Insert toggle into the top hole in the wall.
Repeat with a second toggle bolt in the bottom hole. Do not
tighten toggle bolts at this time.
J
Wall--. _ Washer
Toggle Bolt
J