Filter
Top Products
Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of
day cannot be changed during a timed
baking or self-cleaning cycle.
Touch the CLOCK pad.
Touch the number pads.
Touch the START pad.
Make sure the clock is set to the
correct time of day.
To Set the Kitchen Timer
Touch the KITCHEN TIMER
ON/OFF pad.
Touch the number pads until the
amount of time you want shows
in the display. For example, to set
2 hours and 45 minutes, touch 2, 4
and 5 in that order. If you make a
mistake touch the KITCHEN TIMER
ON/OFF pad and begin again.
Touch the START pad.
After touching the START pad, SET disappears;
this tells you the time is counting down, although
the display does not change until one minute has
passed. Seconds will not be shown in the display
until the last minute is counting down.
When the Kitchen Timer reaches :00,
the control will beep 3 times followed
by one beep every 6 seconds until
the KITCHEN TIMER ON/OFF pad
is touched.
The 6-second tone can be canceled by following
the steps in the Special features of your oven
control section under Tones at the End of a
Timed Cycle.
The Kitchen Timer is a minute timer only.
The Kitchen Timer does not control
oven operations. The maximum
setting on the Kitchen Timer is 9 hours
and 59 minutes.
To Reset the Kitchen Timer
If the display is still showing the time
remaining, you may change it by
touching the KITCHEN TIMER ON/OFF pad,
then touch the number pads until the
time you want appears in the display.
If the remaining time is not in the display
(clock, delay start or cooking time are in
the display), recall the remaining time by
touching the KITCHEN TIMER ON/OFF pad
and then touching the number pads to
enter the new time you want.
To Cancel the Kitchen Timer
Touch the KITCHEN TIMER ON/OFF
pad twice.
Your control will allow you to lock out the touch
pads so they cannot be activated when pressed.
To lock/unlock the touch pad controls:
Touch the OVEN LOCKOUT or RANGE
LOCKOUT pad, then touch the START
pad.
The surface unit displays (on models
so equipped) will show LC and the
oven display will show Loc On for
several seconds, then they will go
blank until a cooking pad is touched.
To unlock the control, touch the
OVEN LOCKOUT or RANGE LOCKOUT
pad, then touch the START pad.
If the range control is locked and a
cooking pad is touched, the appropriate
surface display (on models so equipped)
or the oven display will show that the
control is locked.
■ On models with OVEN LOCKOUT only, the
oven will be locked out. The knob-controlled
surface units will still be active.
■ The RANGE LOCKOUT mode affects all
touch pads. No touch pads will work when
this feature is activated.
Oven or Range Lockout (depending on model)
18
Using the clock, kitchen timer and control lockout.