Filter
Top Products
10
Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions
Using the oven controls.
Throughout this manual, features and appearance may vary from your model.
Oven Control, Clock and Timer Features and Settings
COOK TIME ON/OFF Pad
Press this pad and then press the
HOUR
and
MIN.
pads to set the amount of time
you want your food to cook. Turn the
Oven Temperature knob to the desired
temperature. The oven will shut off when
the Cook Time has run out.
TIMER ON/OFF Pad
Press this pad to select the timer feature.
AUTOMATIC OVEN Light
This lights anytime the oven has been
programmed to automatically turn on
or off.
HOUR and MIN. Pads
These pads allow you to set times up to
11 hours and 59 minutes.
As a safety feature, this oven will automatically shut off
after 12 hours. On models with touch pad clock controls this
feature may be deactivated to allow the oven to be left on
for more than 12 hours. To deactivate or reactivate the
Automatic Oven Shut-Off, press and hold both the MIN.
+/– pads for about 4 seconds.
OVEN ON Light
Glows anytime the oven is heating. The
light will flash when the oven automatically
turns off to remind you to turn the Oven
Temperature knob to
OFF.
Oven Temperature Knob
Turn this knob to the setting you want. (On
some models, you must push the knob in
before turning.) The temperature will be
displayed to indicate setting. Display will
change back to time after a few seconds.
PREHEATED Light
Glows when the oven reaches your selected
temperature.
On some models, opening the oven door will not
automatically turn the oven light on. You may use
the oven light switch to turn the light on and off.
CLEAN Light
Glows when the oven is in the self-clean
cycle. After the self-clean cycle, the light will
flash. Unlatch the door and turn the Oven
Temperature knob to
OFF.
Do not lock the oven door with the latch during cooking.
The latch is used for self-cleaning only.
TEMP RECALL
Press the – pad above
TEMP RECALL
to
display the selected oven temperature.
Display
Shows the time of day and the time set
for the timer.
If “F—and a number or letter” flash in the display
and the oven control signals, this indicates a function
error code.
If your oven was set for a timed oven operation and a
power outage occurred, the clock and all programmed
functions must be reset.
The time of day will flash in the display when there has
been a power outage.
CLOCK Pad
Press this pad before setting the clock.
START TIME ON/OFF Pad
Press this pad and the
HOUR
and
MIN.
pads to delay the starting of your oven
up to 11 hours and 59 minutes.