Filter
Top Products
30
Problem Possible Causes What To Do
Display goes blank
A fuse in your home may be • Replace the fuse or reset the circuit breaker.
blown or the circuit
breaker tripped.
The clock is in the • See the
Special features of your oven control
section.
black-out mode.
Display flashes
Power failure. • Reset the clock.
Unable to get the
Oven control pads were • The
BAKE
and
BROIL HI/LO
pads must be pressed
display to show “SF”
not pressed properly. at the same time and held for 3 seconds.
Power outage,
Power outage or surge. • Reset the clock. If the oven was in use, you must reset
clock flashes
it by pressing the
CLEAR/OFF
pad, setting the clock
and resetting any cooking function.
“Burning” or “oily”
This is normal in a new • To speed the process, set a self-clean cycle for a
odor emitting from
oven and will disappear minimum of 3 hours. See the
Using the self-
the vent
in time.
cleaning oven
section.
Strong odor
An odor from the insulation • This is temporary.
around the inside of the
oven is normal for the first
few times the oven is used.
Troubleshooting Tips
Before You Call For Service …
Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions