Filter
Top Products
Flooring Under the Range
Your range, like many other household
items, is heavy and can settle into soft
floor coverings such as cushioned vinyl or
carpeting.
men
moving the range on this type
of flooring, use care and follow these simple and
inexpensive instructions.
The range should be installed on a 1/4 inch thick
sheet of plywood (or similar material) as follows:
When the
floor covering ends at the front of the
range, the area that the range will rest on should
be built up with plywood to the same level or
higher than the floor covering. This will allow
the range to be moved for cleaning or servicing.
STEP 2
PREPARE FOR ELECTRICAL CONNECTION
Use only a 3-conductor, or if required a
4-
conductor
U.L.
listed range cord. These cords
may be provided with ring terminals on wire and
a strain relief device.
A range cord rated at 40 amps with 125/250
minimum volt rating is required. A 50 amp range
cord is not recommended but if used, it should
be marked for use with nominal
1
%“ diameter
connection openings. Care should be taken to
center cable and strain relief within knockout
hole to keep cable from rubbing the edge.
NOTE: A 4-conductor cord is to be used only
when the appliance is installed in a mobile home
or when local codes do not permit grounding
through the neutral. If conduit is being used, go
to STEP 6.
STEP 3
POWER CORD STRAIN RELIEF INSTALLATION
A. Remove the lower rear range wiring cover to
expose the connector block and bracket.
B. Remove the knockout ring (1%”) located on
bracket directly below the connector. To remove
the knockout, use a pair of pliers to bend the
knockout ring away from the bracket and
tiist
until ring is removed.
BEFORE
BRACKET
C. Assemble the strain relief in
the hole.
Insert the power cord through the strain relief
and tighten. Allow enough slack to easily attach
the cord terminals to the connector block. If tabs
are present at the end of the winged strain relief,
they can be removed for better fit.
NOTE: Do not install the power cord without a
strain relief.
D
ET
STRAIN RELIEF
BRACKET (PROVIDED
WITH RANGE CORD.
NOT PART OF RANG E.)
%
4F
@
7
G
0
K-
7
0
0
II
b
%3
(continued
next page)
31