31
QUESTIONS?
USE THIS PROBLEM SOLVER
PROBLEM POSSIBLE CAUSE
“F–AND A NUMBER • This is a function error code. Press CLEAR/OFF. Allow the oven to cool one
OR LETTER” FLASH hour. Place the oven back into operation.
IN THE DISPLAY
• Disconnect all power to the oven for 5 minutes and then reconnect power.
If the failure code repeats, call for service.
DISPLAY GOES BLANK • The circuit breaker in your house has been tripped, or a fuse has been blown.
DISPLAY FLASHES • Power failure. Reset the clock.
UNABLE TO GET THE • BAKE and BROIL HI/LO must be pressed at the same time and held for
DISPLAY TO SHOW “SF” 2 seconds.
CONTROL SIGNALS AFTER • This is reminding you to press BAKE and then enter a temperature.
ENTERING COOKING TIME
• This is reminding you to enter a bake temperature after having
OR DELAY START TIME
pressed BAKE.
CLOCK AND TIMER • Make sure the electrical plug is plugged into a live, properly grounded
DO NOT WORK power outlet.
• Check for power outage.
• See the Oven Control, Clock and Timer section.
SURFACE UNITS NOT • Surface units are not plugged in solidly.
FUNCTIONING PROPERLY
• Surface unit controls are not properly set.
OVEN WILL NOT WORK • The plug on the range is not completely inserted in the electrical outlet.
• The circuit breaker in your house has been tripped, or a fuse has been blown.
• The oven controls are not properly set.
FOOD DOES NOT • Oven controls not set properly. See the Broiling section.
BROIL PROPERLY
• Door not left open to the broil stop position as recommended.
• Improper shelf position being used. See the Broiling Guide.
• Food is being cooked on a hot pan.
• Cookware is not suited for broiling.
• Low voltage. See the Broiling section.
• Aluminum foil used on the broiler pan and grid has not been fitted properly
and slit as recommended.
(continued next page)
Care and Cleaning Problem Solver