Filter
Top Products
19
Customer ServiceInstallation Instructions Troubleshooting Tips
Operating InstructionsSafety Instructions
Using the clock and timer.
Not all features are on all models.
To Set the Clock
The clock must be set to the correct time of
day for the automatic oven timing functions
to work properly. The time of day cannot be
changed during a timed baking or self-
cleaning cycle.
Press the
CLOCK
pad.
Depending on which model you have,
you will set the clock by pressing either
the number pads or
+
or
–
pads.
Press the number pads the same way you
read them. For example, to set 12:34, press
the number pads
1, 2, 3
and
4
in that order.
If number pads are not pressed within one
minute after you press the
CLOCK
pad, the
display reverts to the original setting. If this
happens, press the
CLOCK
pad and reenter
the time of day.
Press the
START
pad. This enters the
time and starts the clock.
To check the time of day when the display is
showing other information, simply press the CLOCK
pad. The time of day shows until another pad is
pressed.
Make sure the clock is set to the
correct time of day.
To Set the Timer
The timer does not control oven operations.
The maximum setting on the timer is 11 hours
and 59 minutes.
Press the
KITCHEN TIMER ON/OFF
pad.
Press the
+
or
–
or number pads to set
the time. For example, to enter 2 hours
and 45 minutes, touch
2, 4
and
5
in
that order.
If you make a mistake, press the KITCHEN TIMER
ON/OFF pad and begin again.
Press the
START
pad. After pressing the
START
pad,
SET
disappears; this tells
you the time is counting down,
although the display does not change
until one minute has passed.
When the timer reaches
:00,
the
control will beep 3 times followed by
one beep every 6 seconds until the
KITCHEN TIMER ON/OFF
pad is pressed.
The 6 second tone can be canceled by following
the steps in the Special features of your oven
control section under Tones at the End of a Timed
Cycle. Display then shows the time of day.
The timer is a minute timer only.
The CLEAR/OFF pad does not affect
the timer.
Power Outage
If a flashing time is in the display, you have
experienced a power failure. Reset the clock.
To reset the clock, press the
CLOCK
pad.
Enter the correct time of day by pressing the
+
or
–
or the appropriate number pads.
Press the
START
pad.