Filter
Top Products
Before You Call For Service…
Problem Possible Causes What To Do
Oven will not self-clean
The oven temperature is too • Allow the range to cool to room temperature and
high to set a self-clean operation. reset the controls.
Oven controls improperly set. • See the
Using the self-cleaning oven
section.
On models with a door latch, • Make sure you move the door latch handle all the
the oven door is not in the way to the right.
locked position.
“Crackling” or
This is the sound of the • This is normal.
“popping” sound
metal heating and cooling
during both the cooking and
cleaning functions.
Excessive smoking
Excessive soil. • Press the
CLEAR/OFF
pad. Open the windows to
rid the room of smoke. Wait until the
LOCKED DOOR
light goes off. Wipe up the excess soil and reset the
clean cycle.
Oven door will not open
Oven too hot. • Allow the oven to cool below locking temperature.
after a clean cycle
Oven not clean after a
Oven controls not properly set. • See the
Using the self-cleaning oven
section.
clean cycle
Oven was heavily soiled. • Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
“LOCK DOOR” flashes
The self-clean cycle has been • Close the oven door.
in the display
selected but the door is not
closed.
LOCKED DOOR light
The oven door is locked • Press the
CLEAR/OFF
pad. Allow the oven to cool,
is on when you want
because the temperature and then, on models with a door latch, unlock
to cook
inside the oven has not the door.
dropped below the
locking temperature.
“F—and a number or
On models with a door latch, • The latch may have been moved, even if only slightly,
letter” flash in the display
if a function error code appears from the locked position. Make sure the latch is moved
during the self-cleaning cycle, to the right as far as it will go.
check the oven door latch.
You have a function error code. • Press the
CLEAR/OFF
pad. Allow the oven to cool for one
hour. Put the oven back into operation.
If the function code repeats. • Disconnect all power to the range for 5 minutes
and then reconnect power. If the function error
code repeats, call for service.
Oven door will not
Oven is too hot. • Allow the oven to cool below locking temperature.
unlock (on models with
Do not lock the door with the door latch except when
a door latch)
using the self-clean feature.
Operating Instructions
46
Safety InstructionsInstallation InstructionsTroubleshooting TipsCustomer Service
Troubleshooting Tips