Filter
Top Products
Oven Light Bulbs (on some models)
NOTE: The glass cover should be
removed only when cold. Wearing latex
gloves may offer a better grip.
CAUTION: Before replacing your
oven light bulb, disconnect the electrical
power to the oven at the main fuse or
circuit breaker panel.
Be sure to let the light cover and bulb
cool completely.
For your safety, do not touch a hot bulb
with bare hands or a damp cloth.
To remove:
Turn the glass cover
counterclockwise 1/4 turn until the
tabs of the glass cover clear the
grooves of the socket.
Using gloves or a dry cloth, remove
the bulb by pulling it straight out.
To replace:
Use a new 130-volt halogen bulb,
not to exceed 50 watts.
Using gloves or a dry cloth, remove
the bulb from its packaging. Do not
touch the bulb with bare fingers.
Push the bulb straight into the
receptacle all the way.
Place the tabs of the glass cover into
the grooves of the socket. Turn the
glass cover clockwise 1/4 turn to
engage.
For improved lighting inside
the oven, clean the glass cover
frequently using a wet cloth. This
should be done when the oven is
completely cool.
Reconnect electrical power to
the oven.
Bulb
Socket
Tab
Glass cover
Use gloves
or cloth
Receptacle
Receptacle
www.GEAppliances.com
Burner Grates, Vent Grille and Vent Grille Cap
Porcelain enamel burner grates, vent
grille and vent grille cap should be
washed regularly and, of course, after
spillovers.
Wash them in hot, soapy water and
rinse with clean water. You may also use
abrasive cleaners and scouring pads, if
needed. Dry them with a cloth—don’t
put them back on the cooktop wet.
Although they’re durable, the grates,
vent grille and vent grille cap will
gradually lose their shine, regardless of
the best care you can give them. This is
due to their continual exposure to high
temperatures.
Do not operate a burner for an extended
period of time without cookware on the
grate. The finish on the grate may chip
without cookware to absorb the heat.
After cleaning, first replace the vent grille
and the vent grille cap.
Replace the side grates so that they fit
over the tabs on the vent grille. Make
sure the grates are positioned securely
over the burners and that they are stable
and level.
Rubber Grate Feet
For stability, your cooktop has rubber
feet on the burner grates. If any of these
rubber feet should become damaged or
lost, replace them immediately.
To order replacement rubber grate feet,
please call our toll-free number:
National Parts
Center . . . . . . . . . . . . . . . . . . .800.626.2002
Rubber Grate Feet . . . . . . .#WB02T10101
23
Safety Instructions
Operating Instructions Care and Cleaning
Troubleshooting Tips
Consumer Support
Air inlet
Vent grille
Vent grille
cap