Filter
Top Products
Problem Possible Causes What To Do
Display flashes “bAd” The installed connection • Contact installer or electrician to correct miswire.
then “linE” with a from the house to the unit
loud tone is miswired.
Control signals after You forgot to enter a •Touch the BAKE pad and desired temperature or
entering cooking time bake temperature or the SELF CLEAN pad and desired clean time.
or delay start cleaning time.
Display goes blank A fuse in your home may •Replace the fuse or reset the circuit breaker.
be blown or the circuit
breaker tripped.
The clock is in • See the Using the clock and timer section.
black-out mode.
Display flashes Power failure. •Reset the clock.
Unable to get the Oven control pads were • The BROIL HI/LO and BAKE pads must be touched at
display to show “SF” not touched properly. the same time and held for 3 seconds.
Power outage, Power outage or surge. • Reset the clock. If the oven was in use, you must reset
clock flashes it by touching the CLEAR/OFF pad, setting the clock
and resetting any cooking function.
“Burning” or “oily” This is normal in a new oven • To speed the process, set a self-clean cycle for a
odor emitting from and will disappear in time. minimum of 3 hours. See the Using the self-cleaning
the vent oven section.
Strong odor An odor from the insulation • This is temporary.
around the inside of the oven
is normal for the first few
times the oven is used.
Fan noise A cooling fan may • This is normal. The cooling fan will turn off and on
automatically turn to cool internal parts. It may run after the oven is
on and off. turned OFF.
30
Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions
Before you call for service…
Troubleshooting Tips