Filter
Top Products
12
Safety InstructionsOperating InstructionsCare and CleaningTroubleshooting TipsConsumer Support
Using the clock and timer.
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of
day cannot be changed during a timed
baking or self-cleaning cycle.
Press the
CLOCK
pad.
Press the number pads.
Press the
START
pad.
Make sure the clock is set to the
correct time of day.
To Set the Timer
Press the
KITCHEN TIMER ON/OFF
pad.
Press the number pads until the
amount of time you want shows
in the display. For example, to set
2 hours and 45 minutes, press
2, 4
and
5
in that order. If you make a
mistake press the
KITCHEN TIMER
ON/OFF
pad and begin again.
Press the
START
pad.
When the timer reaches
:00
,
the control will beep 3 times
followed by one beep every 6
seconds until the
KITCHEN TIMER
ON/OFF
pad is pressed.
The 6 second tone can be canceled by
following the steps in the
Special features
of your oven control
section under
Tones
at the End of a Timed Cycle.
NOTE: On some models the time counts down
immediately when the START pad is pressed. The
timer is actually counting down in seconds that
are not shown on the display until the last minute.
The timer is a minute timer only.
The timer does not control oven
operations. The maximum setting on
the timer is 9 hours and 59 minutes.
To Reset the Timer
If the display is still showing the time
remaining, you may change it by pressing
the
KITCHEN TIMER ON/OFF
pad, then
press the number pads until the time
you want appears in the display.
If the remaining time is not in the display
(clock, delay start or cooking time are in
the display), recall the remaining time by
pressing the
KITCHEN TIMER ON/OFF
pad
and then pressing the number pads to
enter the new time you want.
To Cancel the Timer
Press the
KITCHEN TIMER ON/OFF
pad twice.