Filter
Top Products
14
Safety InstructionsOperating InstructionsCare and CleaningTroubleshooting TipsCustomer Service
Using the clock and timer.
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of
day cannot be changed during a timed
baking or self-cleaning cycle.
Press the
CLOCK
pad.
Press the
INCREASE
or
DECREASE
pads.
Press the
START
pad.
Make sure the clock is set to the
correct time of day.
To Set the Timer
Press the
KITCHEN TIMER ON/OFF
pad.
Press the
INCREASE
or
DECREASE
pads until the amount of time you
want shows in the display.
If you make a mistake press the
KITCHEN TIMER ON/OFF
pad and
begin again.
Press the
START
pad.
When the timer reaches
:00
, the
control will beep 3 times followed by
one beep every 6 seconds until the
KITCHEN TIMER ON/OFF
pad is
pressed.
The 6 second tone can be canceled by following
the steps in the Special features of your oven
control section under Tones at the End of a
Timed Cycle.
The timer is a minute timer only.
The timer does not control oven
operations. The maximum setting
on the timer is 9 hours and 59
minutes.
To Reset the Timer
If the display is still showing the time
remaining, you may change it by pressing
the
KITCHEN TIMER ON/OFF
pad, then
press the
INCREASE
or
DECREASE
pads
until the time you want appears in the
display.
If the remaining time is not in the display
(clock, delay start or cooking time are in
the display), recall the remaining time by
pressing the
KITCHEN TIMER ON/OFF
pad
and then pressing the
INCREASE
or
DECREASE
pads to enter the new time
you want.
To Cancel the Timer
Press the
KITCHEN TIMER ON/OFF
pad
twice.
Power Outage
After a power outage, when power is
restored the display will flash and time
shown will no longer be correct—
for
example, after a 5-minute power interruption
the clock will be 5 minutes slow.
The display flashes until the clock is reset.
All other functions that were in operation
when the power went out will have to be
programmed again.