Filter
Top Products
To turn on the warmer surface element:
Touch the ON/OFF pad, then touch
the WARMER pad. The surface
element will turn on to warmer
power setting W1 (low).
Use the (+)/(-) pad to choose
additional settings of W2(medium)
and W3 (high).
To turn off the warmer power settings,
touch the ON/OFF pad. To change from
the warmer settings to regular cooking
settings, press the WARMER pad. The
surface element will be on power setting
L (low). The surface element may then
be set to the desired setting using the
(+)/(-) pads. To turn off the surface
element, touch the ON/OFF pad again.
Food Type Control Setting
Breads/Pastries W1 (LOW)
Sauces W2 (Medium)
Soups (cream) W2 (Medium)
Stews W2 (Medium)
Vegetables W2 (Medium)
Hot Beverages W3 (HIGH)
Soups (liquid) W3 (HIGH)
The chart above shows initial suggested settings
only. The temperature, type and amount of food,
and the time held will affect the quality of the
food.
CAUTION: Do not warm food on the WARMER
for more than two hours.
Do not use plastic wrap to cover food. Plastic
may melt onto the surface and be very difficult
to remove.
Use only cookware recommended for top-of-range
cooking.
The WARMER will keep hot, cooked food
at serving temperature. Always start with
hot food. Do not use to heat cold food.
Placing uncooked or cold food on surface
warmer could result in foodborne illness.
For best results, all food on the
WARMER should be covered with a lid or
aluminum foil. When warming pastries
or breads, the cover should be vented to
allow moisture to escape.
Always use potholders or oven mitts when
removing food from the WARMER as
cookware and plates will be hot.
A hot surface indicator light will glow
when the glass surface is hot and will
remain on until the surface has cooled
below 150°F.
ON
OFF
OR
To turn on a single surface element:
Touch the ON/OFF pad, then touch
the (+)/(-) pad.
Use the (+)/(-) pad to choose the
desired power setting. The control
will beep each time a pad is touched.
To turn off a single surface element,
touch the ON/OFF pad again.
Single Surface Element
www.GEAppliances.com
7
Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips
Consumer Support
Dual Surface Element
The dual surface element has a pan
sizing sensor which will automatically set
the small or large surface element to
match the size of your pan (see the Using
Pan Sizing section). To override the
automatic pan sizing sensor and select
the small or large surface element:
Touch the dual surface element
ON/OFF pad.
Use the (+)/(-) pad to set the desired
power setting.
Touch the SIZE SELECT pad once to
turn on the large surface element.
Touch the pad again to turn on the
small surface element.
When the indicator light next to the
SIZE SELECT pad is on, the large surface
element is on. When it is off, the small
surface element is on.
To turn the dual surface element off,
touch the ON/OFF pad.
ON
OFF
OR
SIZE SELECT
Warmer Surface Element
ON
OFF
OR
WARMER