Filter
Top Products
Wire cover holder
Oven Light Bulb
(on some models)
NOTE: The glass cover (on some
models) should be removed only when
cold. Wearing latex gloves may offer a
better grip.
Before replacing the bulb, disconnect
electrical power to the oven at the main
fuse or circuit breaker panel. Let the bulb
cool completely before removing it. For
your safety, do not touch a hot bulb with a
damp cloth. If you do, the bulb will break.
To remove:
Turn the glass cover counterclockwise
1/4 turn until the tabs of the glass cover
clear the grooves of the socket. Remove
the bulb.
To replace:
Put in a new 40-watt appliance bulb.
Place the tabs of the glass cover into the
grooves of the socket. Turn the glass
cover clockwise 1/4 turn.
NOTE:
■
A 40-watt appliance bulb is smaller than a
standard 40-watt household bulb.
■
Reconnect electrical power to the oven.
■
For improved lighting inside the oven, clean
the glass cover frequently using a wet cloth.
This should be done when the oven is
completely cool.
Bulb
Socket
Tab
Maximum
length
3
1
⁄2”
Glass cover
Oven Light Bulb
(on some models)
CAUTION: Before replacing your oven
light bulb, disconnect the electrical
power to the oven at the main fuse or
circuit breaker panel.
Be sure to let the light cover and bulb
cool completely.
To remove the cover:
Hold a hand under the cover so it
doesn’t fall when released. With
fingers of the same hand, firmly
push back the wire cover holder.
Lift off the cover.
Do not remove any screws to remove
the cover.
Replace bulb with a 40-watt
appliance bulb.
To replace the cover:
Place it into groove of the light
receptacle. Pull wire forward to
the center of the cover until it
snaps into place.
Connect electrical power to
the oven.
28
Safety InstructionsOperating InstructionsCare and CleaningTroubleshooting TipsCustomer Service
Care and cleaning of the oven.