Filter
Top Products
Cooktop
Light
To replace
Be sure bulbs to
cooktop
light, first
be replaced are
disconnect power
cool before
at main fuse or
removing. Break
circuit breaker
the adhesive seal
panel or pull
by gently
REMOVE SCREW
plug.
unscrewing the
bulbs. Replace
Remove screw on right side of light compartment cover
with 40-watt incandescent bulbs (WB02X4253)
and lower cover until it stops.
available from your GE supplier. High intensity 40-watt
bulbs (40S 1
lN/1), which are available in supermarkets
and hardware stores, may also be used for replacements.
Raise light compartment cover and replace screw.
Connect electrical power to microwave oven.
Oven Light
To replace
your oven light, first
disconnect power at main fuse or
circuit breaker panel or pull
plug. Remove the top grill by
taking out the 2 screws that hold it
in place.
Next, remove the single screw
located above door near center of
oven that secures light housing.
Replace burned-out bulb with a
30-watt incandescent bulb
(WB02X4235), available from
your GE supplier.
Clean off the grease and dust on
hood surfaces often. Use a solution
of warm water and detergent.
About
1
tablespoon of ammonia
may be added to the water. Take
care not to touch the filters and
enamel surfaces with this solution;
ammonia will darken metal.
This appliance must be grounded.
In the event of an electrical short
circuit, grounding reduces the risk
of electric shock by providing an
escape wire for the electric current.
This appliance is equipped with a
power cord having a grounding
wire with a grounding plug. The
plug must be plugged into an outlet
that is properly installed and
PREFERRED
METHOD
R
@@
+
Ensure proper ground
Fig. 1
exists before use
grounded. (Fig. 1)
Consult a qualified electrician or
. .
.- .
. .
Where a standard two-prong
wall receptacle is encountered, it
is your personal responsibility and
obligation to have it replaced with
a properly grounded three-prong
wall receptacle.
Do not under any circumstance
cut or remove the third (ground)
prong from the power cord.
Do not use an adapter plug with
this appliance.
WARNING–improper
use of the grounding
plug
can-
result in a risk of electric shock.
service
tecnmclan
lr
the
grounalng
instructions are not completely
Do not use an extension cord
understood, or if doubt exists as to
with this appliance.
whether the appliance is properly
grounded.
29