Filter
Top Products
TRASH BAG INSTALLATION
Reinforced polyethylene bags come with your
compactor. These bags are ready to be installed.
You must use the specially designed heavy-duty
trash bags included with your compactor. Replacement
bags can be obtained by calling 800.626.2000. The part
number for replacement bags for your model is
WC60X5015.
• With trash drawer pulled
out to first stop, move the
drawer to the second stop
by lifting the front of the
drawer slightly and pulling
forward. Now lower the
front edge of the drawer
to the floor allowing the
rear wheels to remain on
the track. This will clear
the back of the container
from the cabinet for easy
installation of the bag.
• Set bag caddy into
drawer.
• Set trash bag into bag
caddy and fold over rear
of drawer only.
• Lift drawer in front
and reengage wheels on
track so that the drawer
is self-supporting at its
outermost position.
• Open container latch on
right side of drawer and
swing door open.
• Pull bag over front of
drawer and smooth and
shape the bag to conform
to the drawer. Hook the
prepunched holes in the
bag over the drawer
buttons.
• Gently swing door shut,
assuring that the door
guide ‘‘V’’ is aligned
properly with the ‘‘V’’
groove in the drawer
and that the bag is
captured just above
the “V” groove.
• Finally, use the container
latch to completely close
the door. This will pull
the door guide ‘‘V’’ snug
in the ‘‘V’’ groove in the
drawer flange and tightly
grasp the bag.
Failure to align the ‘‘V’’s properly or to latch the
drawer to the door may cause the compactor to
not function properly.