Filter
Top Products
ATTACH THE MOUNTING
PLATE TO THE WALL
B2.
16
Attach the other 28″ foam tape to the front of
the mounting plate around both of the exhaust
openings where it will touch the microwave.
11
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
B3.
PREPARING THE REAR WALL
FOR OUTSIDE BACK EXHAUST
(continued)
B1.
House
Duct
Damper Swings Free
Fit the exhaust adaptor into the house duct as
shown. Make sure the exhaust adaptor (with the
damper) is squared up in the house duct and lines
up with the holes in the mounting plate.
Remove the paper from the sticky side of the 28″
foam tape. Press the sticky side onto the face of the
exhaust adaptor. (Don’t stretch the foam tape.)
Foam
Mounting
Plate
Damper Hinge On Top
9
Tabs
• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes
in the cabinet bottom.
Wall
Mounting
Plate
Spacing for Toggles More
Than Wall Thickness
Toggle
Bolt
Toggle Wings
To use toggle bolts:
Bolt End
Installation Instructions
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
10
Attach the plate to the wall using toggle bolts. At least
one wood screw must be used to attach the plate to a
wall stud.
Remove the toggle wings from the bolts.
Insert the bolts into the mounting plate through the
holes designated to go into drywall and reattach the
toggle wings to
3
⁄4″ onto each bolt.
1
2
Place the mounting plate against the wall and
insert the toggle wings into the holes in the wall to
mount the plate.
NOTE: Before tightening toggle bolts and wood
screw, make sure the tabs on the mounting plate
touch the bottom of the cabinet when pushed flush
against the wall and that the plate is properly
centered under the cabinet.
CAUTION: Be careful to avoid pinching fingers
between the back of the mounting plate and the wall.
Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.
3
4