GE PCT916 Oven User Manual


 
5
Cutout for 30 (76.2 cm) Single Built-In
Ovens only
For JCTP30, JCTP70, PCT916, PCT920 models only.
A
Cabinet Width 76.2 cm (30)
Recommended
Cutout Location
from Floor 82.6 cm (32 1/2)
Cutout Depth 59.7 cm
(23 1/2) Min.
Cutout Width 72.4 cm
(28 1/2) Min.
72.7 cm
(28 5/8) Max.
Cutout Height 69.2 cm
(27 1/4) Min.
69.4 cm
(27 5/16) Max.
If the cabinet does not have a solid bottom,
two braces or runners must be installed
level with the bottom of the cutout to
support the weight of the oven. For single
ovens, the runners and braces must
support 68 kg (150 lbs.).
Installation Instructions
C
L
SUITABLE
BRACING
TO SUPPORT
RUNNERS
2" x 4" or
EQUIVALENT
RUNNERS
21 5/8"
OVER CENTERLINE
OF CABINET
Suitable
Bracing
to Support
Runners
5 cm x 10 cm
(2 x 4) or
equivalent
runners level
with bottom
of cutout
54.9 cm
(21 5/8)
Over Centerline
of Cabinet
NOTE: If marks, blemishes or the
cutout opening are visible above the
installed oven, it may be necessary to
add wood shims under the runners and
front trim until the marks or opening
are covered.
NOTE: If the cabinet does not
have a front frame and the sides
are less than 1.9 cm (3/4) thick,
shim both sides equally to
establish the cutout width.
Allow a minimum
of 53.3 cm (21)
for clearance to
adjacent corners,
drawers, walls, etc.
when door is open
24.1 cm
(9 1/2)
Max.
Recommended
cutout location
from floor
82.6 cm (32 1/2)
Junction Box
Location
55.9 cm (22)
to Bottom of
Junction Box
53.3 cm
(21)
Cutout
Height
69.2 cm
(27 1/4) Min.
69.4 cm
(27 5/16) Max.
Cutout Width
72.4 cm
(28 1/2) Min.
72.7 cm
(28 5/8) Max.
Opening
between
inside walls
must be at
least 72.4 cm
(28 1/2) wide
Allow 1.75 cm
(11/16)
for overlap
of oven over
side edges of
cutout
Cabinet
Width
76.2 cm (30)
Allow 2.5 cm (1)
for overlap of
oven top and
3.2 cm (1
1
4
)
bottom of cutout
These ovens are not approved
for stackable installation.