GE PDW9200 Series Dishwasher User Manual


 
Installation Instructions
11
Figure HH
STEP 16 PRE-TEST CHECK LIST
Review this list after installing your dishwasher to
avoid charges for a service call that is not covered
by your warranty.
Check to be sure power is OFF.
Open door and remove all foam and paper
packaging.
Locate the Owners Manual in the literature
package.
Read the Owners Manual for operating
instructions.
Check door opening and closing. If door does not
open and close freely or tends to fall, check spring
cable routing and spring adjustments. See Step 1.
Check to be sure that wiring is secure under the
dishwasher, not pinched or in contact with door
springs or other components. See Steps 8 and 10.
Check door alignment with tub. If door hits tub,
level dishwasher. See Step 11.
Pull lower rack out, about half way. Check to be
sure it does not roll back or forward on the door.
If the rack moves, adjust leveling legs. See Step 11.
Check door alignment with cabinet. If door hits
cabinet, reposition or relevel dishwasher. See
Steps 10, 11 and 12.
Check that door spring does not contact water
line, fill hose, wiring or other components. See
Step 13.
Verify water supply and drain lines are not kinked
or in contact with other components. Contact with
motor or dishwasher frame could cause noise. See
Steps 6 and 8.
Turn on the sink hot water faucet and verify waterep 11. Read ret 8w9 T4oaet withurn on the sink hot waterT*03 Tf-1.090.3is an1f-0.8945 0 TD0.0004 Tw( Readrn on the sink w4l dD0 Tw AdD0ek w4l dD0 Tw AdD0ek w4l dD3b0 136 an door hits)Tj0.1964L8945 0 TD (eai uTjskt( Read re 4 T09 rc19 ek w4l dD3b0 136 an door hits)Tj0.19erating)Tj-6.333333333333333333333333333333333333333333333333333333333333333333333333333333333333333333333333333333333333333333333333333333.oic1 T5A()Tb-1.0909 -1.ij/ao on3333330n9ose p0ek833333333333333c 4333 w4l relevel dish6rhot watp9n35.TJ( an1f-0.8 i.ts)cw4l Rir1p66.e/33339ssd