Filter
Top Products
27
Safety Instructions
Operating Instructions Care and Cleaning
Troubleshooting Tips
Consumer Support
ge.com
Problem Possible Causes What To Do
“F— and a number You have a function • Press the Clear/Off pad. Allow the oven to cool for
or letter” flash error code. one hour. Put the oven back into operation.
in the display
If the function code repeats. • Disconnect all power to the oven for at least 30
seconds and then reconnect power. If the function
error code repeats, call for service.
Display goes blank A fuse in your home may • Replace the fuse or reset the circuit breaker.
be blown or the circuit
breaker tripped.
The clock is in the •See the Special features of your oven control section.
black-out mode.
Display flashes Power failure. • Reset the clock.
Unable to get the Oven control pads were • The Bake and Broil Hi/Lo pads (on double oven
display to show “SF” not pressed properly. models, use the upper oven controls) must be
pressed at the same time and held for 3 seconds.
“PROBE” appears in This is reminding you to • Enter a probe temperature.
the display enter a probe temperature
after plugging in the probe.
Power outage, Power outage or surge. • Reset the clock. If the oven was in use, you must reset
clock flashes it by pressing the Clear/Off pad, setting the clock
and resetting any cooking function.
Steam from the vent When using the convection • This is normal.
feature, it is normal to see
steam coming out of the
oven vent. As the number
of racks or amount of
food being cooked increases,
the amount of visible steam
will increase.
“Burning” or “oily” This is normal in a new oven • To speed the process, set a self-clean cycle for a
odor emitting from and will disappear in time. minimum of 3 hours. See the Using the self-cleaning
the vent oven section.
Strong odor An odor from the insulation • This is temporary.
around the inside of the
oven is normal for the first
few times the oven is used.
Fan noise A cooling fan or a convection • This is normal. The cooling fan will turn on
fan (depending on the to cool internal parts. It may run for up to 1-1/2
function you are using) hours after the oven is turned off. The convection
may automatically turn on. fan will cycle on and off until the function is over
or the door is opened.