GE PKD915 Food Warmer User Manual


 
Consumer Support Troubleshooting Tips Installation Instructions Care and Cleaning Operating Instructions Safety Instructions
14
Step 1—Install Anti-Tip Brace
WARNING: ANTI-TIP PRECAUTIONS:
The anti-tip brace must be installed to prevent
the drawer from tipping forward when opened
and loaded.
Failure to do so could result in personal injury.
Install 2x4 or 2x2 anti-tip brace
against rear cabinet wall 9
from floor to bottom of brace
2x4 or 2x2 runners
or solid bottom
9
Provide Cabinet Support
IMPORTANT: When installed below a single or
double oven, check to be sure that any oven
supports above the cutout do not obstruct the
23
1
2required depth of the warming drawer
cutout.
A 2minimum clearance between oven
and warming drawer cutouts are required.
Additional clearance may be required if
2 x 4 blocks are used to support runners or
solid floor of the oven above.
The warming drawer may be supported by
either a solid bottom, 2 x 4 or 2 x 2 runners.
The support must be level and rigidly
mounted, flush with the bottom edge
of the cutout.
There is no way to level the drawer once it
has been installed. Be sure supports are level.
The entire weight of the drawer is supported
by the runners or solid floor and must be
capable of supporting 150 lbs.
23
1
2
22
27
2x 4 or equivalent runners
23
1
2
25
30
2x 4 or equivalent runners
Installation of the warming drawer.
Read these instructions completely and carefully.