Filter
Top Products
Installation Instructions
FAUCET ASSEMBLY (cont.)
BATTERY INSTALLATION
1. Use a small flat blade screwdriver or coin
to remove the battery tray (A) at the side
of the faucet base.
2. Install one CR2032, 3 volt battery (B)
+ side down into the battery tray (A).
3. Slide tray into faucet base (C) until the
battery tray (A) edge is flush with the side
of the base.
4. The blue light (D) will flash 5 times,
indicating a proper installation and system
reset. If you want to reinitiate the start-up
sequence, remove the battery for 45–60
seconds; the electronics need to fully
discharge. Then put the battery back in.
5. The light is normally off. After 6 months
of use, the light will flash again every
30 seconds, indicating the proper time
to replace the filter cartridge.
NOTE: The blue light may stop blinking if
allowed to blink for an extended period of
time. To ensure proper operation, the battery
should be replaced with every filter change.
OPTIONAL ONE PERSON
FAUCET TUBING INSTALLATION
1. From under the sink, gather the 1/4″ drain
line (black), 3/8″ drain line (black) and 3/8″
outlet tube (blue banded) in one hand with
the drain tubes the same length and the
outlet tube offset approximately 6 inches.
2. Wrap a rubber band around all 3 tubes.
3. Insert a typical No. 2 pencil through the
rubber band location.
4. Rotate the pencil down until it is in line
with the tubing and push up through the
mounting hole. Release the grip on the
pencil and the tubes will remain in
position for easier faucet connection.
+
–
(B) Battery
(C) Faucet base
(A) Battery
tray
(D) Blue light
14