Filter
Top Products
Problem Possible Causes What To Do
Water has air bubbles Air in system after installation. • Will go away after it runs for a while.
and is cloudy
Indicator light on faucet Batteries installed incorrectly • Observe orientation on page 14 and install correctly.
base not working or expended. Replace batteries if old.
Blue light does not • Normal operation.
illuminate until 6 months.
Batteries are dead. • Use new CR2032, 3-volt battery.
Chlorine taste and/or The ppm of chlorine in your
• If the water supply contains more than 2.0 ppm of chlorine,
odor in the Reverse water supply exceeds maximum additional filtering of the water supply to the Reverse
Osmosis product water limits and has destroyed the Osmosis is needed. Correct this condition before doing
Reverse Osmosis membrane. maintenance on the Reverse Osmosis system.
The prefilter is no longer • Replace the Reverse Osmosis membrane cartridge,
removing chlorine from flow control, screen, prefilter, postfilter and batteries
the water supply. in the electronics box.
Other taste and/or odor High quality product water • This is normal.
may have a different taste
than what you’re used to.
Low water usage. • Completely drain system and allow to refill.
Contamination in product • Use sanitizing procedures.
water storage.
Prefilter and postfilter
• Replace the prefilter and postfilter.
need to be changed.
• Sanitize system.
Water leaking from Drain side of faucet air gap • Inspect and eliminate restriction or plug. It is important
faucet air gap hole (3/8″ tubing) plugged, that there are no dips, loops or low spots in the drain line
restricted or incorrectly from the faucet air gap to the drain pipe. Refer to
connected to the drain. Installation Instructions for proper drain connection.
If drain line adapter was used as the drain point,
periodic inspection/cleaning is recommended.
System makes product This is normal. • Water flow rate will be lower than your regular faucet.
water slowly
• It takes 3–4 hours to fill the tank.
Water supply to the Reverse • Increase water pressure, precondition the water, etc.,
Osmosis system not within as needed to conform before doing maintenance on
specifications. the Reverse Osmosis system.
Prefilter cartridge plugged • Replace the prefilter.
If rate does not increase,
replace
with sediments.
the
postfilter, Reverse Osmosis membrane cartridge,
flow control and batteries in the faucet base.
Reverse Osmosis membrane • Replace Reverse Osmosis membrane cartridge, flow
plugged with sediments.
control and battery in the faucet base.
Before you call for service…
ge.com
Troubleshooting Tips
Save time and money! Review the charts on the following
pages first and you may not need to call for service.
Consumer SupportTroubleshooting Tips
Operating InstructionsSafety Instructions
Installation Instructions
21