Filter
Top Products
Drawers Cmw”s
(continued)
The drawercover
supportassembly
consistsof a post,
a sleeveand a foot.
The sleeveandpost
haveadjustment
teeth which, when
engaged,lockthem
together;and when
disengaged,allow
the sleeveto move
up anddown freely
in thepost.
The supportassemblyis adjusted
at the factory.Toreadjustit, if
necessary:
1. Makesure the supportassembly
is firmly attachedto the drawer
cover (seepage 9) and the drawer
coveris in place inthe cabinet.
2. Make surethe adjustmentteeth
are disengaged.(If engaged,rotate
the sleeve1/4turn counterclockwise
to disengagethem.) Withthe footof
the supportassemblyresting on the
cabinet floor and the sides ofthe
cover resting on the ledgeson the
cabinet’sside walls,turn the sleeve
1/4turn clockwise tore-engage the
teeth. Note: If teethdo not mesh,
movethe sleeveup slightlyas you
turn it. Do notraisethedrawercover.
To reinstall the
foot ifit comes
off, guide the pins
D
u
—
on the footinto the
slots at the bottom
t
*
.
of the sleeve. Then
/’
rotate the foot
clockwise until the
pins snap firmly
into place.
Meat
rnodek equipped)
I
Fresh meatsare storedbest in
thecoldestpart ofthe refrigerator.
When this drawerisplacedin the
top 6 slotson the leftside and the
leveris set at COLDEST, air from
the freezer is forced around the
drawerto keep itvery cold.
Youcan movethe drawerto any
locationfor storageof itemsother
than fresh meats.
The variable
t control
lever lets you regulatethe amount
of cold air surrounding the drawer.
When the kver
i all the way up,
the damper over the opening in the
drawer is fully open to providethe
coldest storagearea.
when. the kver is
a t way
down, the damper is fully closed.
Normal refrigerator temperatures
will be maintained.
Variable settings between these
extremes may be selected.
h-x
W@pped)
--
Yom-!iCemakek-willpmhm eight
cubes per cycl-—-app~~ximately –
100cubesin a 24-hourperiod,
dependingon freezercompartment
temperature, roomtemperature,
numberof door openingsand other
use conditions.
If your refrigeratoris operated
beforewaterconnection is made
to the icemaker,keepthe icemaker
feeler arm in the OFF (up) position
as shownbelow.
Feeler Arm in
W .
S Bin
‘$f%xw
When r has b~~~
connected t water supply?move
the feeler arm to the ON (down)
position.
Feeler Arm in
ON position
—
Ice cube mold will automatically
:.
fill with water after cooling to
:..
.
,L,:.”
freezing temperature, and first
~.
.
~.
?.-
,
cubes will normally freeze after
.
!:..,
.
[“
:
several hours. When cubes are
f;
:
solidly frozen, they will be ejected
~,;
from the mold into the ice storage
~:;
.
bin by means of a sweeper arm.
10