Filter
Top Products
11
Installation
Stainless Steel Interior Dishwasher
Step 3
Install
Water Inlet
Fittings
Step 4
Install
power cord
(If used)
Skip this step
If dishwasher
will be wired
direct.
• Install the 90° elbow onto the water inlet.
Use thread sealing tape or pipe thread
compound.
• The 90° elbow should face the left or right
side, depending on water line routing.
• Install strain relief onto junction box and
tighten against incoming wires.
• Strip 1/2” insulation from end of power
cord wires.
• Connect incoming wires to dishwasher wires
using wire nuts of appropriate size.
• Connect the white to white, black to black
and incoming ground to green wire.
• Push all wires into the junction box and
secure cover with screws onto dishwasher
frame.
Note: The power cord and connections must
comply with the National Electrical Code,
Section 422 and/or local codes and
ordinances.
IMPORTANT: The power cord must be no
longer than 6 ft from the junction box to the
plug. DO NOT PLUG IN POWER CORD AT
THIS TIME.
Screw F