Filter
Top Products
Installation Instructions
TOOLS REQUIRED
• Tinsnips to cut banding
• Stepladder
• Bucket
• i,evel
• Appliance Hand T_uck
• Tubing cutter
• 7/16" open-end wrench
• #9 Phillips screwdriver
• Drill and ai)propriate bits
• 5/]6", 7/16" socket
• Satety glasses
• l-I/4" open end wrench
• Plie_
• 1/4" ratchet
HARDWARE SUPPLIED
• X*Vaterfilter byl)ass plug
• Anti-Tip brackets
• 1/4" nut and teHule
MATERIALS REQUIRED
• 35" long 2x4 fl_r Anti-Tip support
• 1/4" COl)per water line tubing or GE
SmartConnecg" Refrigerator Tubing kits
• X_'ater sh ut-ofl wflve
• C/IStOIll panels tot fl'esh tood door, fl'eezer drawer
and grille panel
• Screws to secure refrigerator to cabinetry:
• Stick-on hook and loop fastener strips for
1/4" side panels
FLOORING
For proper installation, this refl'igerator must be
placed on a level sm'lace of hard material that is at
the same height as the rest of the flooring. This
sm'lace should be strong enough to support a flfllv
loaded refrigerator, or approximately 1,200 lbs.
NOTE: Protect tile finish of tile flooring. Cut a large
section of tile cardboard carton and place trader tile
refrigerator where you are working.
GROUNDING THE REFRIGERATOR
IMPORTANT_(Please read carefully)
FOIl PERSONAl, SAFETY, THIS APPI,IANCE MUST
BE PROPERI,Y GROUNDED.
Tile power cord of this appliance is equipped with
a 3-prong (gro/mding) plug which nlates with a
standard three-prong (grounding) wall receptacle
to minimize tile possibility of electric shock hazard
fl'om this appliance.
Have the wall outlet and circuit checked by a
qualified electrician to make sure tile outlet is
properly gro/mded.
OR REMOVE THE THIRD
(GROUND) PRONG FROM
THE POWER CORD.
Where a standard 2-prong wall outlet is encountered,
it is wmr personal responsibility and obligation to
have it replaced with a properly gro/mded 3-prong
wall outlet.
DO NOT, UNDER ANY _----9_I_
CIRCUMSTANCES, CUT
DO NOT USE AN ADAPTER PIJJG TO CONNECT
THE REFRIGERATOR TO A 2-PRONG OUTI,ET.
DO NOT USE AN EXTENSION CORD WITH THIS
APPI,IANCE.
9