Filter
Top Products
NOTE: The glass cover should be removed only when
cold. Wearing latex gloves may offer a better grip.
CAUTION: Before replacing the
bulb, disconnect electrical power to the hood
at the main fuse or circuit breaker panel.
ATTENTION : Avant de remettre
en place l’ampoule, débranchez le courant de la
hotte en enlevant le fusible principal ou en faisant
basculer le disjoncteur au panneau d’alimentation.
Be sure to let the light cover and bulb cool
completely.
For your safety, do not touch a hot bulb with
bare hands or a damp cloth.
To remove:
1 Insert your finger nail into the inner glass
cover slot and pull down. Remove cover.
NOTE: Do not remove outer retaining ring.
2 Using gloves or a dry cloth, remove the bulb
by pulling it straight out.
To replace:
1 Use a new 12-volt, 20-watt Halogen bulb for
a G-4 base.
2 Using gloves or a dry cloth, remove the new
bulb from its packaging.
NOTE: Do not touch the new halogen bulb with
bare fingers. Touching the bulb with bare fingers
will significantly reduce the life of the bulb.
3 Push the bulb straight into the receptacle
all the way.
For improved lighting, clean the glass cover
frequently using a damp cloth. This should be done
when the hood is completely cool.
4 Snap the glass cover into the retaining ring.
5 Reconnect electrical power to the hood.
7
Care and Cleaning
Chimney Vent Hood
Stainless steel
surfaces
(on some models)
Do not use a steel wool pad; it will scratch
the surface.
To clean the stainless steel surface, use warm
sudsy water, a stainless steel cleaner such as
Kleen King
®
or an all-purpose liquid or spray
cleaner. Always scrub in the direction of the
grain. Rinse thoroughly with a sponge or cloth
and clean water. Dry with a soft, clean cloth.
After cleaning, use a stainless steel polish, such
as Stainless Steel Magic
®
, Revere Copper and
Stainless Steel Cleaner
®
or Wenol All Purpose
Metal Polish
®
. Follow the product instructions
for cleaning the stainless steel surface.
Glass visor
Pull the glass visor out and wash it with a damp
soapy cloth. Dry it with a clean cloth and push it
back into place.
Painted
Surfaces
(on some models)
Clean any painted surfaces with a mixture
of water and either soap or vinegar.
Do not use commercial oven cleaners, cleaning
powders, steel wool or harsh abrasives on any
painted surface.
Light bulbs
Receptacle
Use gloves or
cloth
Bulb
Socket
Glass cover
Receptacle
ONLY use a new 12-volt, 20-watt Halogen bulb for a
G-4 base.