GE Monogram ZBD0710 Dishwasher User Manual


 
19
Before You Call For Service
Dishwasher
Questions?
Use this
problem
solver
PROBLEM POSSIBLE CAUSE WHAT TO DO
Sanitized light does not The door was opened and Do not interrupt the cycle any time during
illuminate at the end of the cycle was interrupted or after main wash.
the cycle (Anti-Bacteria during or after the main
cycle only) wash portion
Low inlet water Raise the water heater temperature to
temperature at least 120°F (49°C).
Interior lights not Door was open for more Latch the door and reopen.
working than 15 minutes
Bulbs are burned out Call for service to replace bulbs.
End-of-cycle indicator Dishwasher has not Open the door and check the status
light does not illuminate completed cycle indicator lights on control panel to
determine if cycle is complete.
Beeps every 30 seconds Door was opened Close the door to complete the cycle.
during the cycle
START/RESET light blinks START/RESET pad was Dishwasher will pump out for approximately
pressed during the cycle 70 seconds and blinking light will turn off.
Power failure during Dishwasher will pump out for approximately
the cycle 70 seconds and blinking light will turn off.
Dishwasher will automatically restart using
NORMAL WASH and HEATED DRY.