Filter
Top Products
12
Built-In Dimensions
Beverage Center
Cut-out dimensions:
Height: 34
1
/2
–35″ (876–889 mm)
Width: 24″ (610 mm) minimum
Depth: 24″ (610 mm) minimum
Installation
dimensions
The beverage center can be a free-
standing model or can be built in using
the cut-out dimensions below.
When building in the beverage center,
be sure to allow for a full door swing so
you have full access to the pull-out full
extension drawers.
See the Installation Instructions (Pub. No.
49-60210-2) for complete directions.
34
1
/
2
″
(876 mm)
23
3
/
4
″
(603 mm)
23
3
/
4
″
(603 mm)
Product dimensions:
Height: 34
1
/2″ (876 mm)
Width: 23
3
/4″ (603 mm)
Depth: 23
3
/4″ (603 mm)
Note:
Handle and
handle standoff
depth is 1
3
/4″
Product
clearances
The beverage center is factory set for a
110° door swing.
When installed in a corner:
• Allow 4″ minimum clearance on the
hinge side for the 90° door swing and
to allow racks to slide out.
• Allow 10″ minimum clearance on the
hinge side for a full 110° door swing.
• The door swing is reversible on all
models. If desired, change the door swing
before installation.
Choose the location:
• These products may be closed in on the
top and three sides as long as the front
is unobstructed for air circulation and
proper access to the door.
• Do not install these products where the
temperature will go below 55°F (13°C)
or above 90°F (32°C).
• Do not install where it will be subject to
direct sunlight, heat or moisture.
Black or Stainless Steel Toekick Options
These products are shipped with a black
toekick installed. An optional stainless
steel toekick is also supplied with each
product. For shipping purposes, the
stainless steel toekick is secured to the
back of the unit.
10" Minimum
to Wall
110°
20-7/8"
23-5/8"
4" Minimum
to Wall
90°
90° Door Swing