Filter
Top Products
Controls and Features
Beverage Center
Interior light
and switch
The interior light makes it easy to view
your beverage labels and enhances the
display of your collection.
When the switch is in the OFF position,
the light comes on only when the door
is opened. When the switch is in the ON
position, the light remains on continuously
for your maximum viewing pleasure. For
best viewing, do not store a bottle on
the top shelf directly under the light.
Remember to turn off the light when
it is no longer needed.
Glass shelves
Tempered glass shelves in the beverage
center unit are removable for easy
cleaning or for storing larger items.
To remove a shelf, open the door
completely to avoid potential damage to
the gasket. Lift up on the back of the shelf
slightly. Tilt the shelf to one side at an
angle while pulling forward.
To replace a shelf, open the door
completely to avoid potential damage
to the gasket. Tilt the shelf to one side
at an angle and slide toward the back wall,
placing one side onto the shelf support.
Place the other side onto the opposite
shelf support. Ensure rear locking tabs
are engaged. When installed properly,
the shelf will not slide forward when
gently pulled.
Temperature
control
The operating temperatures of the
beverage center range from the low forties
to the mid fifties.
Do not install the beverage center where
the temperature will go below 55°F (13°C)
or above 90°F (32°C).
As with any refrigeration product, there is
a slight temperature variance at different
locations within the cabinet.
The coolest area will be in the lower part
of the cabinet.
The cooler area will be in the middle
section.
The upper part of the cabinet is the
warmest section.
When the temperature is adjusted, allow
24 hours for the unit to stabilize.
To set the control, turn it to the midpoint
setting (approximately 45ºF). Once the
beverage center is loaded, allow at least
24 hours before making any adjustments
to the initial setting.
8
To remove, lift up on the back of the shelf Tilt the shelf at an angle while removing
or replacing
Place in slots when replacing the shelf