Filter
Top Products
11
Gasket
The main door and icemaker compartment
gaskets may be cleaned with mild soap
and water, a baking soda solution or a mild
scouring powder. Rinse and dry well after
cleaning.
After cleaning the gaskets, apply a thin
layer of paraffin wax or petroleum jelly
to the gaskets. This helps keep the gaskets
from sticking and bending out of shape.
Light bulb
replacement
Turn the bar refrigerator with icemaker OFF
before replacing the light bulb.
To remove the light shield, pull the tab in
the bottom center of the shield. Replace
with a 15 watt appliance bulb.
In the event
of a power
failure
If the power fails, open the door as
infrequently as possible to maintain
the temperature.
Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
Preparing
for vacation
For long vacations or absences, remove
food and turn the bar refrigerator with
icemaker OFF. Clean the interior (see
Cleaning the Inside section)
For shorter vacations, remove perishable
foods and leave controls at regular settings.
However, if the room temperature is
expected to drop below 60°F (16°C), follow
the same instructions as for long vacations.
Set the icemaker power switch to the O (off)
position and be sure to shut off the water
supply to the refrigerator.
Preparing
to move
Secure all loose items such as shelves and
drawers by taping them securely in place to
prevent damage.
Be sure the bar refrigerator with icemaker
stays in an upright position during
moving.
Care and Cleaning
Bar Refrigerator with Icemaker
Turn the bar refrigerator with icemaker OFF or unplug the unit before cleaning.
Turn the bar refrigerator with icemaker OFF by pressing the button on the control panel
a minimum of 3 seconds until the light turns off.
For your
safety