Filter
Top Products
9
Controls and Features
Bar Refrigerator with Icemaker
Automatic
icemaker
The icemaker will produce seven cubes
per cycle—approximately 100–130 cubes
in a 24-hour period, depending on freezer
compartment temperature, room
temperature, number of door
openings and other use conditions.
If the bar refrigerator with icemaker is
operated before the water connection is
made to the water valve, set the icemaker
power switch to O (off).
When the unit has been connected to
the water supply, set the icemaker power
switch to I (on). The green light will come on.
The icemaker will fill with water when it
cools to 15°F (–10°C). A newly installed
bar refrigerator with icemaker may take
12 to 24 hours to begin making ice cubes.
You will hear a buzzing sound each time
the icemaker fills with water.
Throw away the first few batches of ice
to allow the water line to clear.
Be sure nothing interferes with the sweep
of the feeler arm.
When the bin fills to the level of the feeler
arm, the icemaker will stop producing ice.
It is normal for several cubes to be joined
together.
If ice is not used frequently, old ice cubes
will become cloudy, taste stale and shrink.
If ice cubes get stuck in the icemaker,
the green power light will blink. To correct
this, set the icemaker power switch
to O (off) and remove the cubes.
Set the icemaker power switch
to I (on) to restart the icemaker.
After the icemaker has been turned
on again, there will be a delay of about
45 minutes before the icemaker resumes
operations.
NOTE: In homes with lower-than-average
water pressure, you may hear the
icemaker cycle multiple times when
making one batch of ice.
Icemaker
Feeler Arm
Power Switch
Green
Power Light
Ice storage
bin
To remove, pull the icemaker drawer fully
open and remove the transportable ice
storage bin by lifting up and out.
NOTE: Ice can fall behind the ice storage bin.
Prior to replacing the bin, check for any fallen
ice.
If the ice storage bin is removed from
the refrigerator for an extended period of
time, we recommend setting the icemaker
power switch to O (off).
To replace, grasp the side of the right side
of the bin with the higher edge so that the
angled side is against the drawer front.
Lower the bin into place and close the
drawer.
CAUTION: Failure to install properly could
cause potential damage to the icemaker.
The ice storage bin is dishwasher safe,
top rack only.