Filter
Top Products
3/4″ Overlay Panel Dimensions
Model ZIDI240 requires field-installed
overlay drawer panels.
• The overlay panels must be secured to
1/4″ thick backer panels that slide into
the trim. A 0.10″ thick spacer panel must
be placed between the overlay and
backer panels.
• Custom handles of your choice, supplied
by your cabinet maker, must be installed
on these overlay panels. Countersink all
screws into the backer panels. Screws
cannot protrude from the backer panels.
NOTE: Maximum total weight for custom
drawer panels are 25 lbs. (12
1
⁄2 lbs. max.
each drawer).
Assemble overlay panels with glue
and screws
1. Center spacer
panel on the
backer panel,
left to right and
top to bottom.
Secure the panels
with glue.
2. Center the spacer/backer panel on the
overlay panel. Secure with glue and
screws. Countersink all screws into the
backer panel.
14
Built-In Dimensions/Installation
Double-Drawer Refrigerator
Product
clearances
On stainless steel model ZIDS240, allow
22″ min. clearance from the front of the
double-drawer for drawer opening.
On custom panel model ZIDI240, allow
23
1
⁄8″ min. clearance from the front of the
double-drawer for drawer opening.
When installed into a corner, allow 2
1
⁄2″ min.
clearance between double-drawer and
adjacent cabinet, wall or other appliances.
NOTE: Clearances are based on the
recommended 2
1
⁄8″ handle standoff depth.
Custom handle clearances may vary
depending on the standoff of the custom
handles.
When installed in a corner:
Black or Stainless Steel Toekick Options
Your custom panel (ZIDI240 model only)
double-drawer refrigerator is shipped with
two toekicks, a stainless steel and a black
toekick. For shipping purposes, one of
the toekicks will be secured to the back or
inside of the unit, and the second will be
installed on the unit. Keep the unused
toekick and other unused or removed
parts for possible future use.
Clearance for Door
Opening 2-1/2" min.
Countertop
Double-Drawer
22" (with Custom Panels
23-1/8" min.)
Overlay
Panel
1/4"
Backer
Panel
Door
0.10"
Spacer
Installing
custom 3/4″
drawer panels
and handles
(ZIDI240 model
only)
12
1
⁄2 lbs. max.
A
B
Spacer Panel
Backer Panel
Overlay Panel
3/4″ Overlay Panel Dimensions
(in inches)
A (Width) B (Height)
1/4″ Backer 23
3
⁄16″ 14
11
⁄16″
0.10″ Spacer 22
1
⁄2″ 14
3
⁄16″
3/4″ Overlay 23
5
⁄8″ 15
1
⁄16″
12
1
⁄2 lbs. max.
*
B
*Maintain a 1/4″ min. gap between
top and bottom drawer panels.