Filter
Top Products
5
3 – CONTROLS AND OPERATIONS
1. The mixing paddles feature adjustable rubber wipers and steel backing plates.
Paddles are factory preset for appropriate drum wrap clearance. If adjustment is
required, proceed as follows:
A. Loosen the wiper attaching hardware and move the wiper outward to
maintain contact with the drum but without folding over when in
operation.
B. After adjustment, turn the mixer arms one full turn manually to check
clearance and eliminate the possibility of wiper back plates contacting the
drum.
2. Read through the manual for all operation, adjustment and maintenance
instructions. Be sure all engine/motor and drive system operation instructions are
followed as outlines.
3. All nuts and cap screws should be checked and tightened during the first two (2)
hours of use. Periodic checks should be made thereafter.
CLUTCH CONTROL LEVER
This control is located in front of the mixing drum on the mixer leg. SEE FIGURE 1.
This control engages and disengages the drive to the mixing blades.
TO ENGAGE: Position lever in line with the mixer frame (12 o’clock position). Lever
is held in the engage position by the over-center action of the linkage.
TO DISENGAGE: Push lever down (counter-clock-wise) to the 9 o’clock position.
Lever is spring loaded to hold it in the disengaged position.