Filter
Top Products
3
2. Place the plastic skids (shipped with the convertible refrigerator/
freezer) on the floor at least 3 ft. (91.44 cm) apart. Lay a piece of
cardboard or other protective material over the skids. This will
elevate the convertible refrigerator/freezer to allow for easier
caster installation and also protect it from scratches.
NOTE: If the skids have been discarded or are not available,
2" x 4" boards may be used.
3. Place the convertible refrigerator/freezer on its side on top of the
cardboard or protective material. Make sure the door hinge is
facing upward.
IMPORTANT: It is important that the door hinge face upward
during the entire caster installation.
4. Remove the caster and fasteners from the box.
5. Locate and remove the caster brackets from the FeaturePak.
6. Using ⁵⁄₁₆–18 hex-head bolts, attach 1 rigid caster and 1 swivel
caster to each caster bracket. The rigid caster fits the front of the
bracket, and the swivel caster fits on the rear.
7. Insert the hex-head bolts from the bottom and start the self-
locking nuts for each caster.
8. Hold the head of the hex-head bolt with a wrench while
tightening the self-locking nuts with a socket wrench.
9. Using a ¹⁄₂" socket wrench, remove the 4 unit bolts (2 on each
side) from the lower front and rear of the convertible refrigerator/
freezer.
NOTE: Do not remove the leveling bolt.
Lower Front Corner
10. Place the slot in the rear of the caster bracket over the hole in the
rear of the convertible refrigerator/freezer. Align the hole in the
front of the caster bracket with the hole in the front of the
convertible refrigerator/freezer.
Lower Rear Corner
11. Hold the bracket in place and insert the unit bolts into the front
and rear unit holes and tighten.
NOTE: Do not overtighten the bolts.
12. Insert 2 of the ¹⁄₄–20 x 1 ¹⁄₄" hex-head bolts and lock washers into
the 2 caster bracket holes in the side as shown. Push the caster
bracket against the bottom of the convertible refrigerator/freezer
and tighten the bolts using a ³⁄₈" socket wrench.
13. Repeat steps 10 – 12 for the second caster bracket.
Complete the Assembly
1. Lock the front caster.
NOTE: Locking the casters will help prevent the convertible
refrigerator/freezer from moving while it is being lifted.
2. Insert a small piece of cardboard between the caster brake and
the floor. This will help prevent the brake from rubbing on the
floor.
3. Stand the convertible refrigerator/freezer upright.
4. Replace the base grille by placing the metal clips in the openings
in the metal panel and rolling the grille downward until it snaps
into place.
5. Unlock the casters and move the convertible refrigerator/freezer
into its desired location.
6. After the convertible refrigerator/freezer is in position, lock the
casters again.
A. Top Hinge
B. Center Hinge
A. Self-locking nut
B. Caster bracket
C.
⁵⁄₁₆
–18 x
⁷⁄₈
" hex-head bolt
D. Caster
A.
Leveling bolt (do not remove)
B. Unit bolt
A
B
B
A
C
D
A
B
A. Rear convertible
refrigerator/freezer hole
B. Caster bracket
A. Caster bracket holes
A
B
A