Filter
Top Products
Low Battery
Parent Unit
The Parent Unit is shipped with rechargeable batteries already
installed. The battery must be plugged into the Parent Unit before
the unit will be ready for use.
• Remove the battery door cover on the Parent Unit with a key or
flat blade screw driver.
• Lift the battery out of the compartment, and carefully plug the
battery into the unit.
• Replace the battery and the battery door cover.
• If it becomes necessary to purchase a new battery, remove the
cover, carefully unplug the battery and replace with a new battery.
Replace the battery door cover.
• The Parent Unit can use either the rechargeable battery that comes with the unit or standard 120 volt AC household
current. The Nursery Unit uses standard 120 volt AC household current.
• To use AC adapters, plug the connector on the cord into the AC adapter jack on the side of the Parent Unit and the Nursery
Unit. Then plug adapter into a standard wall outlet.
• Use ONL
Y the Graco adapters included with the unit. Do not use these adapters with other equipment under any
cir
cumstances.
• If units do not work, check that AC adapters are plugged into working outlets.
• When electricity is off (from a power failure, etc.), the Parent Unit will operate on rechargeable batteries, however, the
Nursery Unit will not operate until power is restored.
Parent Unit
• When the battery is low in the parent unit you may plug in the A/C adapter to recharge the batteries.
Out of Range Indication
• If the Parent Unit begins to lose the signal from the Nursery Unit you may hear static or other noise. Immediately move the
Parent Unit closer to the Nurser
y Unit to regain connection.
***Note: It is not uncommon for the Parent Unit to occasionally lose and regain connection with the Nursery
Unit in environments that have a significant amount of obstructions.
Battery Installation
Using AC Adapters
3