Filter
Top Products
• In case you are experiencing some interference, the channel on the Nursery Unit can be changed by switching the channel
button on the side of the unit. The Parent Unit and Nursery Unit must both be set to the same channel, either channel “A”
or “B” (“X” or “Y”).
1. For optimum operation, it is best to use fully charged batteries in the Parent Unit. It is recommended that the batteries in
the Parent Unit be charged for 16 hours prior to initial use.
2. Place the Nursery Unit within 10 feet (3 meters) of your baby. Plug an AC adapter into the jack on the side of the Nursery
Unit. Plug it into a working 120 volt AC outlet.
3. Aim the Nursery Unit toward your baby. Check that there are no walls or large objects that could block sound transmission.
4. Set both the Nursery Unit and Parent Unit to the same channel, “A” or “B” (“X” or “Y”).
5. Turn on the Nursery Unit using the On/Off switch on the side. The green power light should come on.
6. Place the Parent Unit within five (5) feet (1.5 meters) of the Nursery Unit and turn on the Parent Unit using the On/Off
switch on the side of the unit. The green power light should come on. Your monitor is now ready for use.
It is VERY IMPORTANT to test the system when first set up, and at regular times thereafter. Test the units if you
suspect they may have been damaged or have not been used for a long time.
1. If two adults are present, have one take the Parent Unit to different locations, trying various volume settings, while the
other speaks into the Nursery Unit.
2. If only one adult is available, place a ticking clock, radio, or other sound-producing device near the Nursery Unit to test it.
3. When testing, keep the level of your child’s sounds in mind, and adjust the volume accordingly.
4. If there is sound interference, switch the Nursery Unit and the Parent Unit to the other channel setting.
Selecting Channels
Setting Up the Baby Monitor
Testing the System
4