Filter
Top Products
Page 4 Crathco
®
5512 Manual
Installing Y
our Unit
CAUTION: Do not alter or deform the plug in any way. Altering or deforming plug may damage unit
and will void warranty! Receptacle NEMA 6-20R required for Model 5512.
1. Place freezer in a location that allows adequate space at each side and above
for proper air circulation. Minimum clearance is: 6” (15 cm) on both sides, 4”
(10 cm) at back, and 8" (20 cm) above the freezer. See figure B.
CAUTION:
Failure to allow adequate ventilation will void the warranty
and reduce freezer performance.
2. Place the freezer on the self-sealing rubber pad on a level counter that is
stable and strong enough to safely support its weight (276 lbs/124.2 kg). If
equipped with legs instead of pad, install legs by screwing them into the four
leg holes on the bottom of the unit. (Leg Kit Part #W089.0220 (4) 4” Legs.)
3. Place On-Off-Clean switches in OFF position.
4. Install header by removing all four screws from the electrical box cover.
Carefully remove electrical box cover. Place the header (transparency)
between the clear and opaque plates (plastic lens). Slip the electrical
box cover back on to machine and reinsert the four screws.
(See Figure C)
5. Install the standard one piece carb tube by placing it in the hole in the
hopper. If your unit is equipped with a two piece smoothie/shake carb
tube place the solid piece in the hole in the hopper with the hole facing
front to back. Then place the carb tube sleeve over the solid piece, lining
up one of the holes with the hole in the solid piece. (Select the larger
hole for thickest products).
6. Connect the power cord to a properly grounded DEDICATED
20 Amp circuit.
IMPORTANT: See Autofill Installation for information on set up of
remote fill control and proportioning pump assembly.
Installation of Concealed Air Filter Accessory
Kit (optional) (Part #’s W0890200 Stainless Steel, W0890208 Black)
1. Remove the four screws that hold the right side panel on the
machine.
2. Install the filter panel over the existing side panel and reinstall
screws. (See Figure D)
3. Open top cover of filter cover by raising and rotating away from the
existing panel.
4. Slide filter into top of filter cover with removal clip up and the air
flow arrows facing the existing panel. (See Figure E)
5. Push filter down until flush with the top of the cover.
6. Close the top cover by rotating the top back toward the existing
cover and pushing down once it is in place.
Figure C
Figure D
Figure E
INSTALL THE FILTER
PANEL OVER THE
EXISTING SIDE PANEL
& RE-INSTALL SCREWS.
P/N:W0520101, COMES
IN KIT # W0890220
FILTER PANEL
P/N:W0631805 FILTER
SLIDE THE FILTER IN BEHIND THE FILTER PANEL, &
IN FRONT OF THE EXISTING SIDE PANEL.
TO CHANGE REMOVE, CLEAN, & OR REPLACE.
!
Figure B
Proper air
clearance
!