Filter
Top Products
Model H6069 Wet Sharpener-6-
OPERATIONS
Filling Reservoir
To fill the water reservoir:
1. DISCONNECT FROM THE POWER
SOURCE.
2. Loosen the tool rest adjustment lock
handles and move the tool rest away
from the sharpening stone.
3. Fill the water reservoir. See Figure 2
Reduce the risk of electrocution by
keeping all connections dry and off
the ground. DO NOT touch plugs
with wet hands. Failure to follow
these warning could result in seri-
ous injury.
Be sure the cord is positioned with
a “drip loop” below the level of
the outlet as shown above. This
prevents water from running down
the cord and into the outlet. Instead
the water will drip to the floor at the
“drip loop” on the cord.
Figure 2. Tool rest moved away from
sharpening wheel.
4.
With dry hands and a dry plug, con-
nect the wet sharpener into the power
source.
5. Run the wet sharpener for one minute
to properly wet the stone.
6. With dry hands and a dry plug, discon-
nect the saw from the power source.
7. Refill the water reservoir until full and
return the tool rest to the desired loca-
tion.
NOTE—It is important to keep the wheel
well lubricated while sharpening. Unplug
and refill machine as needed to maintain
an appropriate water level.
Fill Here