Grizzly T10125 Kitchen Utensil User Manual


 


Figure 3. Steps
1– 4
Figure 4. 

Figure 5. 
5. 
      Figure 4 

6.     

Figure 5
Note: Your cutterhead may have paper shims
stuck to the bearing block or the part of the
casting where the bearing block rests. These
were included at the factory when they cali-
brated your cutterhead even with the outfeed
table. If you see these, carefully pull them
off and set them aside for later use, or keep
them with your cutterhead in the event that
you reinstall it later. Also, mark the side of
the cutterhead where they were used, so
the future install will go smoothly. Your new
cutterhead may or may not need these.
7.       

8.        

    

9.      Step 8


        

10. 

11.       



Installation
1. 
2.      

3. 
4.      
       
Figure 3
Note:When lowering, make sure that the
fence support does not come in contact with
the cutterhead pulley.

